Isthmus Models

This is an Airtronics 6 Cell 7.2 Volt 2200mAh Ni-MH battery pack for the Airtronics SD-10G transmitter. This is a direct replacement for the stock battery that comes preinstalled in the SD-10G.

Features and Specifications:

• 6 Cells 7.2 Volts
• 2200mAh Capacity
• Universal 'Z' Power Connector

Do a forming charge on this 4-cell receiver battery on your trickle charger for long lasting power. Cycle new batteries a few times for best results. NiMH packs require a "forming charge" if you're ever going to see their maximum capacity realized.

This forming charge must be done at no more than the 10-hour charge rate (1/10C) and ensures that the plates inside the cells are properly conditioned for use.

Specifications

Weight 8oz 226mm
Length 4.1in 103mm
Width 1.1in 29mm
Height 1.1in 29mm

This is an optional higher mAh transmitter battery for the RDS8000 from Airtronics and JR R/C transmitters. Plug must be changed for use in a JR TX.

Do a forming charge on this 4-cell receiver battery on your trickle charger for long lasting power. Cycle new batteries a few times for best results. NiMH packs require a "forming charge" if you're ever going to see their maximum capacity realized.

This forming charge must be done at no more than the 10-hour charge rate (1/10C) and ensures that the plates inside the cells are properly conditioned for use.

For use in Hitec Optic/Eclipse/Prism transmitters.

Do a forming charge on this 4-cell receiver battery on your trickle charger for long lasting power. Cycle new batteries a few times for best results. NiMH packs require a "forming charge" if you're ever going to see their maximum capacity realized.

This forming charge must be done at no more than the 10-hour charge rate (1/10C) and ensures that the plates inside the cells are properly conditioned for use.

This is an Airtronics 6 Cell 7.2 Volt 2200mAh Ni-MH battery pack for the Airtronics M11X and MX-3X transmitter. This is a direct replacement for the stock battery pack that comes with the M11X and can be used in place of the 'AA' Alkaline batteries that power the MX-3X transmitter in the stock configuration. Using this battery pack is more convenient and more cost effective in the long run than using Alkaline batteries.

Features and Specifications:

• 6 Cells 7.2 Volts
• 2200mAh Capacity
• Universal 'Z' Power Connector

Do a forming charge on this 4-cell receiver battery on your trickle charger for long lasting power. Cycle new batteries a few times for best results. NiMH packs require a "forming charge" if you're ever going to see their maximum capacity realized.

This forming charge must be done at no more than the 10-hour charge rate (1/10C) and ensures that the plates inside the cells are properly conditioned for use.